Generator diesel fuel systems
We design and install the fuel system that keeps standby generators running through a long outage: bulk storage, day tanks, transfer pumps, piping and controls.
Fuel that reaches the generator when it starts
We design the whole supply chain from the bulk tank to the generator, then install, test and commission it with your electrical contractor.
- Bulk storage tanks, underground or aboveground
- Day tanks and connections to generator base tanks
- Duplex duty and standby transfer pumps with automatic changeover
- Pump control panels with level switches and alarms
- Fuel filtration and polishing to keep stored diesel clean
- Tank levels and alarms sent to the building management system over Modbus or BACnet
Who it's for
Hospitals, data centres, water and power utilities, airports, telecom sites and large commercial buildings.
How the system runs
Level switches in each day tank start the transfer pumps. If the duty pump fails, the standby pump takes over and an alarm goes to the BMS, so your facility team sees levels and faults in one place.
Common questions
Can you connect the fuel system to our BMS?
Yes. A gateway passes tank levels, pump status and alarms to the BMS over Modbus or BACnet.
Do you work on existing generator fuel systems?
Yes. We survey and test existing systems, replace pumps, controls and tanks, and add monitoring where it is missing.
Why should stored diesel be polished?
Diesel that sits in a tank for months collects water and sludge, which can block filters when the generator starts. Polishing filters the fuel on a schedule so it is ready when needed.
Tell us about your project
Send your drawings, BOQ or a short description. Our engineers will review them and send you a quotation.